Table of Contents
Advertisement
How to Configure the
Remote CAPI Client
How to Configure Remote
CAPI via the Web interface
How to Enable Remote
CAPI via CLI
E-DOC-CTC-20051017-0167 v1.0
The above installation procedure adds the Remote CAP20 Client application to your
system. You can access it via the Control Panel.
Proceed as follows to configure this client:
1
Use the Control Panel to start the Remote CAP20 Client application:
2
In the IP box, enter the IP address of the SpeedTouch™ (192.168.1.254).
3
In the UDP Port box, enter the UDP port if necessary (default is 6789).
4
In the TCP Port box, enter the TCP port if necessary (default is 6789).
Prerequisite:
You need to have RVS Communication Center or any other software that uses the
Rcapi driver.
Procedure:
Proceed as follows to enable Remote CAPI via the Web Interface:
1
On the Web interface home page, click Expert
2
In the navigation pane, click SpeedTouch™
3
Go to SpeedTouch™ Services
4
Select Remote CAPI Daemon
Use the following command sequence to enable RCAPI:
=>rcapi
[rcapi]=>
[rcapi]=>config
[RCAPID] state: disabled
[rcapi]=>config state enabled
Chapter 10
Routed PPPoI
99
Advertisement
Table of Contents
