Table of Contents
Advertisement
5.1 SpeedTouch™ Routed PPPoE Configuration.
Preparatory steps for
using Routed PPPoE
E-DOC-CTC-20051017-0167 v1.0
To be able to configure the SpeedTouch™ successfully for the Routed PPPoE Packet
Service, the following information must be available:
The VPI/VCI value of the Virtual Channel on which the PPPoE connection
service is enabled.
The encapsulation method (normally LLC/SNAP).
The Routed PPPoE interface's IP configuration, either via single IP address, or
via IPCP subnet masking. The latter configuration requires all local nodes to be
configured for DHCP and the SpeedTouch™ DHCP server being active.
The user name and password for the ISP account.
Optionally, a Service name and/or Access Concentrator name.
Chapter 5
Routed PPPoE
39
Advertisement
Table of Contents
