Table of Contents
Advertisement
Chapter 3
Routed Ethernet
Using Routed Ethernet
Protocol stack
18
The Service Provider provides static Public IP addresses to be configured for
the Routed Ethernet interface to uniquely identify the local end worldwide.
By enabling NAPT on the Routed Ethernet interface, the single public IP address can
be shared by nodes on the Local Network.
Using Routed Ethernet is rather straightforward:
1
Make sure that the SpeedTouch™ is turned on first.
2
Turn on the computer(s).
3
Make sure that the Ethernet interface of the host computer is properly
configured.
4
Start a web browser.
You are now on the Internet or you have Corporate Intranet access.
Although the access method of the bridge is Always–On, the remote
organization might still ask for a user name and password.
The figure below shows the Routed Ethernet protocol stack.
ip
mac
eth
PC
CPE
adsl
DSLAM
IP
mac
RFC1483b
AAL5/ATM
PHY
Service
Gateway
E-DOC-CTC-20051017-0167 v1.0
Advertisement
Table of Contents
