Table of Contents
Advertisement
9.1 SpeedTouch™ Routed IP over ATM
Preparatory steps for
using Routed IPoA
Interface road map
E-DOC-CTC-20051017-0167 v1.0
Configuration
To be able to configure the SpeedTouch™ successfully for the Routed IPoA Packet
Service, the following information must be available:
The VPI/VCI value of the Virtual Channel on which the IPoA connection service
is enabled
The encapsulation method (in most, if not all cases LLC/SNAP)
The Routed IPoA local and remote interfaces' IP configuration
The figure below shows the interfaces which have to be configured for Routed IPoA.
ARP
IPoE /
PPPoE
IPoEoA
Ethernet Interface(s)
VLAN
Bridge
Physical Ports
(Eth, USB, WLAN, BT...)
Interfaces connected with red arrows are by default created and connected.
Interfaces connected with blue arrows need to be created and connected.
The colours used correspond with the colours used in the
LoopBack
IP Forwarding
IP Interface(s)
PPP
PPPoE RELAY
PPPoA
EthoA
ATM Interface(s)
ATM Bundle
ATM VP/VC
(Over DSL / ATM-F)
Chapter 9
Routed IPoA
iARP
Multilink
IPoA
PPP
ISDN
" Protocol
stack".
77
Advertisement
Table of Contents
