Configuration Making Use Of Ilmi (Autopvc) - THOMSON SpeedTouch Configuration Manual

6.1.2 Configuration making use of ILMI (autoPVC)

Configuration procedure
E-DOC-CTC-20051017-0167 v1.0
Proceed as follows to configure the PPPoE Relay interface using ILMI:
1
Add a new (embedded) PPP interface.
=>ppp ifadd intf=autoPPP
=>
2
Configure the PPP interface (user name and password for the ISP) and with
destination RELAY.
=>ppp ifconfig intf=autoPPP user=johnDoe@ISP password=johnDoe
dest=RELAY
=>
3
Create a route that will be added to the routing table when the PPP link comes
up.
=>ppp rtadd intf=autoPPP dest=0.0.0.0/0
=>
4
Configure the PPP relay.
=>ppp relay ifadd intf=bridge
=>ppp relay ifadd intf=autoPPP
=>
5
Activate the autoPVC.
=>autopvc config mode=active type=pppoerelay
=>
6
Execute save all at the prompt to save this configuration.
=>saveall
=>
For a complete description of all CLI commands, refer to the SpeedTouch™
CLI Reference Guide.
Chapter 6
PPPoE Relay
57