Table of Contents
Advertisement
Chapter 2
Bridged Ethernet
The ATM interface
14
The configuration procedure consists of the following steps:
1
Create, configure and attach/connect the ATM interface.
2
Create, configure and attach/connect the Bridge interface.
3
Check your configuration.
Proceed as follows to create an ATM phonebook and the ATM interface.
1
Add a new phone book entry with name BrETHoA_ph, VPI/VCI =8.35.
=>atm phonebook add name=BrEthoa_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete that entry first.
2
Add a new ATM interface with name BrETHoA_atm.
=>atm ifadd intf=BrEthoa_atm
=>
3
Configure the new ATM interface with as destination the phonebook entry
created above.
=>atm ifconfig intf=BrEthoa_atm dest=BrEthoa_ph ulp=mac
=>
By default, the encapsulation method will be LLC/SNAP.
4
Connect the ATM interface to the phonebook entry.
=>atm ifattach intf=BrEthoa_atm
=>
E-DOC-CTC-20051017-0167 v1.0
Advertisement
Table of Contents
