THOMSON SpeedTouch Configuration Manual page 104

Chapter 10
Routed PPPoI
CLI Parameters:
96
The table below provides a description of the relevant parameters. Do not alter the
default value of the parameters not shown in this table:
Parameter Value
intf text string
dest text string
user text string
password text string
auth pap, chap or auto
restart enabled or disabled
retryinterval numeric
passive enabled or disabled
silent enabled or disabled
echo enabled or disabled
mru numeric
lPaddress IP address
raddress IP address
netmask Format depends on
the format setting
format cidr, dotted or none
savepwd enabled or disabled
Description
name of the PPP interface
name of the ISDN interface on which
the PPP connection is built
Username needed for the PPP
connection
Password needed for the PPP
connection
Sets the authentication protocol
Enable or disable the retry function.
This means that the system will try
again if establishing the link fails.
If the connection fails, and restart is
enabled, the system will retry
establishing the connection after this
interval.
Enable or disable passive mode
Enable or disable silent mode
Enable or disable echo
Local IP address of the PPP
connection. This is completed
automatically when establishing the
connection. Do not fill it in manually.
Remote IP address of the PPP
connection. This is completed
automatically when establishing the
connection. Do not fill it in manually.
Netmask for the ppp connection.
This is completed automatically
when establishing the connection.
Do not fill it in manually.
Set the format of the netmask to cidr
or dotted, or use no netmask.
Save the password. After
establishing the ppp link for the first
time, you no longer need to provide
it for subsequent connections.
E-DOC-CTC-20051017-0167 v1.0