THOMSON SpeedTouch Configuration Manual page 39

Expected results
E-DOC-CTC-20051017-0167 v1.0
To check whether you have configured your connection correctly, take a look at the
interface list. Normally you should be able to follow the path you created. This
interface list shows that the ATM interface with name BrPPPoE_atm is connected to
the bridge. In this way every frame coming from the ATM interface BrPPPoE_atm
will be put on the bridge.
=>:interface list
Name Type
ethif1 physical
ethif2 physical
ethif3 physical
ethif4 physical
RELAY eth
bridge eth
OBC bridge
ethport1 bridge
BrPPPoE_atm atm
BrPPPoE_br bridge
ethport2 bridge
ethport3 bridge
ethport4 bridge
lan1 ip
The items in Italic are the interfaces created in this chapter.
The interface list does not include the ATM phone book entry. To check its state, go
to the ATM phone book list.
=>atm phonebook list
Name Use Address
BrPPPoE_ph 1 8.35
State Use UL Interfaces
connected 1 ethport1
connected 1 ethport2
connected 1 ethport3
connected 1 ethport4
connected 0
connected 1 lan1
connected 1 bridge
connected 1 bridge
connected 1 BrPPPoE_br
connected 1 bridge
connected 1 bridge
connected 1 bridge
connected 1 bridge
connected 0
Chapter 4
Bridged PPPoE
31