Table of Contents
Advertisement
3.1 SpeedTouch™ Routed Ethernet Configuration
Preparatory steps for
using Routed Ethernet
Interface road map
E-DOC-CTC-20051017-0167 v1.0
To be able to configure the SpeedTouch™ successfully for the Routed Ethernet
Packet Service, the following information must be available:
The VPI/VCI value of the Virtual Channel on which the Ethoa connection
service is enabled.
The encapsulation method (in most - if not all - cases LLC/SNAP).
The IP configuration of the Routed Ethernet interface.
The figure below shows the interfaces which have to be configured for Routed
Ethernet.
ARP
IPoE /
PPPoE
IPoEoA
Ethernet Interface(s)
VLAN
Bridge
Physical Ports
(Eth, USB, WLAN, BT...)
LoopBack
IP Forwarding
IP Interface(s)
PPP
PPPoE RELAY
PPPoA
EthoA
ATM Interface(s)
ATM Bundle
ATM VP/VC
(Over DSL / ATM-F)
Chapter 3
Routed Ethernet
iARP
Multilink
IPoA
PPP
ISDN
19
Advertisement
Table of Contents
