Table of Contents
Advertisement
6.1 SpeedTouch™ PPPoE Relay Configuration
Description
Setup
Configuration scenarios
E-DOC-CTC-20051017-0167 v1.0
In this scenario, the end users are connected either via IP or PPPoE. Traffic is sent
over the same VP/VC to the Internet.
Both PPPoE connections (external and embedded) can use different Access
Concentrators.
The figure below shows the setup for the example scenario:
Embedded
PPPoE
IP
IP client with
local IP address
PPPoE
Public IP address
an embedded PPP client on the SpeedTouch™ (red)
a host PPP client on a PC on the LAN (blue)
Two scenarios exist for configuring the SpeedTouch™ Relay. This section gives an
example of the configuration procedure for both scenarios:
1
General configuration scenario
2
Configuration making use of ILMI (autopvc)
Public
DSLAM
IP address
PPPoE
VP/VC: 8/35
Chapter 6
PPPoE Relay
BRAS
Internet
51
Advertisement
Table of Contents
