Table of Contents
Advertisement
8.1 Configuration Procedure for Relayed PPPoA
Introduction
Preparatory Steps for
relayed PPPoA
Configuration procedure
Phone book entry
PPTP service
E-DOC-CTC-20051017-0167 v1.0
The relayed PPPoA Packet Service implies nothing more than creating a pvc and
enabling the PPTP service.
To be able to configure the SpeedTouch™ successfully for the relayed PPPoA
Packet Service, the VPI/VCI value of the Virtual Channel on which the PPPoA
connection service is enabled, must be available.
Proceed as follows to configure Relayed PPPoA:
1
Create a phone book entry.
2
Enable the PPTP service.
3
Proceed with the configuration of the PC as described in
Windows XP Embedded PPP
1
Add a new phone book entry with name BrPPPoA_ph, VPI/VCI =8.35.
=>atm phonebook add name=BrPPPoA_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
1
Enable the PPTP service with the following CLI command:
=>service system modify name=PPTP state=enabled
Client".
Chapter 8
PPTP-to-PPPoA relaying
"8.1.1 Using the
71
Advertisement
Table of Contents
