Evaporative Emission Control System Inspection (For E-33 Only) - Suzuki GSX1300R Manual

1B-15 Emission Control Devices:
Fuel Shut-off Valve
Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Disconnect the surge hose (1).
3) Remove the fuel shut-off valve (2).
Installation
1) Install the fuel shut-off valve as shown in the EVAP
canister hose routing diagram. Refer to "EVAP
Canister Hose Routing Diagram (Only for E-33)
(Page 1B-8)".
2) Reinstall the removed parts.
Evaporative Emission Control System
Inspection (For E-33 only)
Refer to "Evaporative Emission Control System Removal
and Installation (Only for E-33) (Page 1B-14)".
Hose
Inspect the hoses for wear or damage. If it is worn or
damage, replace the hose with a new one.
NOTE
Make sure that the hoses are securely
connected.
EVAP Canister
Inspect the EVAP canister body for damage to the body.
If any defect is found, replace the EVAP canister with a
new one.
2
1
I815H1120024-01
B815H21206010
I815H1120023-01
EVAP System Purge Control Solenoid Valve
NOTE
EVAP system purge control solenoid valve
can be checked without removing it from the
motorcycle. Refer to "DTC "C62" (P0443):
EVAP System Purge Control Solenoid Valve
Circuit Malfunction (E-33 only) in Section 1A
(Page 1A-115)".
1) Check that no air flows through both of the air inlet
and outlet ports. If air flows out, replace the EVAP
system purge control solenoid valve with a new one.
2) Connect the 12 V battery to the terminals of the
EVAP system purge control solenoid valve and
check the air flow. If air flows out, the solenoid valve
is in normal condition.
I718H2120003-03
I718H2120004-01