Suzuki GSX1300R Manual page 207

3) Check the resistance between the terminals of the
EVAP system purge control solenoid valve. If the
resistance is not within the standard range, replace
the EVAP system purge control solenoid valve with a
new one.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
EVAP system purge control solenoid valve
resistance
Approx. 32 Ω at 20 °C (68 °F)
Tank Pressure Control Valve
Inspect the tank pressure control valve body for damage.
Inspect the tank pressure control valve operation in the
following procedures:
1) When air pressure is applied lightly to the tank
pressure control valve from the side "A", air should
flow out through the valve smoothly.
"A"
(A)
I718H2120005-02
I815H1120025-01
Emission Control Devices:
2) When air pressure is applied lightly to the tank
pressure control valve from the side "B", air should
flow out through the valve difficulty.
3) If the tank pressure control valve operates otherwise,
it must be replaced.
WARNING
!
Gasoline and gasoline vapor is toxic. A small
amount of fuel remains in the tank pressure
control valve when checking it. Do not
swallow the fuel when blowing the tank
pressure control valve.
NOTE
When connecting the tank pressure control
valve to the hose, the side "B" should face
toward the fuel shut-off valve side, and the
side "A" should face toward the canister
side.
Fuel Shut-Off Valve
Inspect the fuel shut-off valve body for damage.Inspect
the fuel shut-off valve operation in the following
procedures:
1) When air is blown into the fuel shut-off valve with its
side "A" positioned upward, the air can pass through
to the canister side.
1B-16
"B"
I815H1120026-01
"A"
I823H1120037-01