Suzuki GSX1300R Manual page 410

1J-7 Charging System:
11) Remove the key (7).
7
12) Remove the generator stator (8) along with the CKP
sensor (9).
I815H11A0008-01
9
8
I815H11A0009-01
Installation
Install the generator in the reverse order of removal. Pay
attention to the following points:
• Tighten the generator stator set bolts and CKP sensor
mounting bolts to the specified torque.
NOTE
Be sure the grommet (1) is set to the
generator cover.
Tightening torque
Generator stator set bolt (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
CKP sensor mounting bolt (b): 6.5 N·m (0.65 kgf-
m, 4.7 lb-ft)
(b)
• Degrease the tapered portion "A" of generator rotor
and also the crankshaft "B". Use nonflammable
cleaning solvent to wipe off oily or greasy matter and
make these surfaces completely dry.
• Fit the key (2) in the key slot on the crankshaft.
• Install the generator rotor onto crankshaft.
"A"
1
(a)
I823H11A0012-01
"B"
2
I815H11A0010-01