Throttle Body Removal And Installation - Suzuki GSX1300R Manual

Throttle Body Removal and Installation

Removal
1) Remove the side cowlings. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
2) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation (Page 1D-6)".
3) Disconnect the throttle cables from their drum.
CAUTION
!
After disconnecting the throttle cables, do
not snap the throttle valves from full open to
full close. It may cause damage to the throttle
valves and throttle body.
4) Place a rag under the fuel feed hose (1) and
disconnect the fuel feed hose from the fuel pump.
WARNING
!
For California models, drain fuel from the fuel
tank before disconnect the fuel feed hose to
prevent fuel leakage.
B815H21406010
I815H1140015-01
1
I815H1140016-01
5) Disconnect the TP sensor lead wire coupler (2), STP
sensor lead wire coupler (3) and STVA lead wire
coupler (4).
6) Remove the clamp (5).
3
4
7) Disconnect secondary fuel injector lead wire
couplers (6) and primary fuel injector lead wire
couplers (7).
6
7
8) Disconnect the ISC valve lead wire coupler (8).
Engine Mechanical: 1D-10
5
2
I815H1140017-01
I815H1140018-01
8
I815H1140019-01