Suzuki GSX1300R Manual page 454

2C-9 Rear Suspension:
8) Remove the swingarm pivot shaft.
9) Remove the swingarm.
10) Remove the cushion lever (5) and cushion rods (6).
6
11) Remove the mudguard (7), chain case (8) and chain
buffer (9) from the swingarm.
7
12) Remove the plate (10).
10
5
I815H1230028-02
8
9
I815H1230029-02
I815H1230030-01
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Temporarily install the cushion rod mounting nut.
NOTE
The stamped marks "A" on the cushion rod
should be face out side.
• Adjust swingarm pivot thrust clearance in the following
procedures:
– Insert the swingarm pivot shaft (1) and tighten it to
the specified torque.
Special tool
(A): 09900–18740 (Hexagon socket (24
mm))
Tightening torque
Swingarm pivot shaft (a): 15 N·m (1.5 kgf-m,
11.0 lb-ft)
1
(A)
"A"
I815H1230031-01
(a)
I815H1230032-01