2B-3 Front Suspension:
Installation
1) Set the front fork to the front fork lower bracket
temporarily by tightening the lower clamp bolts (1).
2) Tighten the front fork cap bolt (2) to the specified
torque.
Tightening torque
Front fork cap bolt (a): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
3) Loosen the lower clamp bolts.
4) Set the front fork with the upper surface "T" of the
outer tube positioned 5.0 mm (0.20 in) "a" from the
upper surface of the upper bracket.
"T"
"a": 5.0 mm (0.20 in)
1
I823H1220005-01
" a "
2
(a)
I823H1220006-01
5) Tighten the front fork lower clamp bolts (1).
Tightening torque
Front fork lower clamp bolt (b): 23 N·m (2.3 kgf-
m, 16.5 lb-ft)
6) Tighten the front fork upper clamp bolt (3).
Tightening torque
Front fork upper clamp bolt (c): 23 N·m (2.3 kgf-
m, 16.5 lb-ft)
7) Adjust the spring pre-load (4), if necessary. Refer to
"Front Suspension Adjustment (Page 2B-5)".
8) Install the collars (5).
1
(b)
I823H1220007-01
4
3
(c)
I815H1220006-01
5
I815H1220007-01