Side-Stand / Ignition Interlock System Parts Inspection - Suzuki GSX1300R Manual

Side-stand / Ignition Interlock System Parts
Inspection
Check the interlock system for proper operation. If the
interlock system does not operate properly, check each
component for damage or abnormalities. If any
abnormality is found, replace the component with a new
one.
Side-stand Switch
1) Turn the ignition switch OFF.
2) Remove the left side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
3) Disconnect the side-stand switch coupler (1).
1
4) Measure the voltage between G and B/W lead wires.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
ON
(Side-stand up)
OFF
(Side-stand down)
NOTE
If the tester reads 1.4 V and below when the
tester probes are not connected, replace its
battery.
B815H21906008
I815H1190007-01
G B/W
((+) probe) ((–) probe)
0.4 – 0.6 V
1.4 V and more
(Tester's battery voltage)
I815H1190008-01
5) Connect the side-stand switch coupler.
6) Install the left side cowling. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
Turn Signal / Side-stand Relay
The turn signal/side-stand relay is composed of the turn
signal relay, side-stand relay and diode.
Side-stand relay
1) Remove the turn signal/side-stand relay. Refer to
"Turn Signal / Side-stand Relay Removal and
Installation (Page 1I-7)".
2) Check the insulation between "D" and "E" terminals
using the multi-circuit tester.
3) Apply 12 V to terminals "D" and "C" ((+) to "D" and (–
) to "C") and check the continuity between "D" and
"E". If there is no continuity, replace the turn signal/
side-stand relay with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
"D"
"E"
SIDE-STAND RELAY
DIODE
"A" "B" "C" "D" "E"
Starting System:
I649G1190027-02
)
"C" "B" "A"
"F" "G"
TURN
SIGNAL
RELAY
"F" "G"
I649G1190028-02
1I-8