Suzuki GSX1300R Manual page 608

9A-7 Wiring Systems:
8
"A"
" b "
16
16
1. Clamp
: Bind the wiring harness, starter motor lead wire, generator lead wire, gear
position switch lead wire and HO2 sensor lead wire with the clamp.
2. Clamp
: Bind the wiring harness, speed sensor lead wire and side-stand lead wire
with the clamp.
3. Clamp
: Bind the starter motor lead wire, generator lead wire, gear position switch
lead wire and HO2 sensor lead wire with the clamp.
4. Clamp
: Bind the battery (+) lead wire with the clamp.
5. Clamp
: Bind the wiring harness with the clamp.
6. Clamp
: Bind the license plate light lead wire with the clamp. Cut off the excess end of
the clamp and set the locked part facing inside.
7. Clamp
: Bind the wiring harness and handlebar switch lead wire (RH) with the clamp.
8. Clamp
: Bind the handlebar switch lead wires (LH/RH), ignition switch lead wire and
immobilizer antenna lead wire (E-02, 19, 24) with the clamp.
9. Clamp
: Bind the rear turn signal light lead wire with the clamp.
10. Clamp
: Bind the license plate light lead wire with the clamp.
11. IAT sensor
12. Wiring harness
11
7
3
17
"c " "c "
9
1
2
" a "
13
15
13. Seat rail
14. Oil pressure switch
15. HO2 sensor
16. Ignition switch lead wire
: Pass the ignition switch lead wire on the outside of other lead
wires.
17. Gray taping
: Fasten the clamp on the gray taping. The width of the gray
taping on both the right and left of the clamp be at least 1 mm.
"A": The ignition switch lead wire should not be hidden by other lead
wires when viewed within the range "b".
"a": 5 – 10 mm (0.2 – 0.4 in)
"b": 90°
"c": 1 mm (0.039 in) and more
[A]: Inside of the rear frame cover
[B]: Inside of the rear fender
[A]
4
5
12
14
[B]
I815H1910908-01
6
10