9A-9 Wiring Systems:
1. Gear position switch
2. Oil pressure switch
3. Starter motor
4. CMP sensor
5. CKP sensor
6. Speed sensor
7. Clamp
Service Data
Electrical
Item
Headlight
Signal
Ignition
Fuse size
Fuel
Fan (LH)
Fan (RH)
Main
Tightening Torque Specifications
NOTE
The specified tightening torque is also described in the following.
"Wiring Harness Routing Diagram (Page 9A-5)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C
(Page 0C-9)".
Recommended Service Material
NOTE
Required service material is also described in the following.
"Wiring Harness Routing Diagram (Page 9A-5)"
8. Battery (–) lead wire
"A": When tightening the starter motor mounting bolts, tighten rear one first.
"a": Within 20°
"b": Approx. 30°
: 6.5 N⋅m (0.65 kgf-m, 4.7 lb-ft)
: 6 N⋅m (0.6 kgf-m, 4.3 lb-ft)
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
Specifications
HI
LO
Special Tools and Equipment
Specification
10 A
10 A
10 A
15 A
10 A
15 A
30 A
: 120 N⋅m (12.0 kgf-m, 87 lb-ft)
: 10 N⋅m (1.0 kgf-m, 7.0 lb-ft)
: 1.5 N⋅m (0.15 kgf-m, 1.0 lb-ft)
: 14 N⋅m (1.4 kgf-m, 10.0 lb-ft)
: 5 N⋅m (0.5 kgf-m, 3.5 lb-ft)
: Apply bond to the thread part.
: Apply threaded lock to the
threaded part.
B815H29107001
Note
B815H29107002
B815H29108001