Suzuki GSX1300R Manual page 503

8) Fill the reservoir with brake fluid to the upper mark of
the reservoir.
9) Install the reservoir cap.
Rear Brake
1) Place the motorcycle on a level surface.
2) Remove the frame cover. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
3) Remove the brake fluid reservoir cap and
diaphragm.
4) Suck up the old brake fluid as much as possible.
5) Fill the reservoir with new brake fluid.
BF: Brake fluid (DOT 4)
6) Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
Brake Control System and Diagnosis:
7) Loosen the air bleeder valve and pump the brake
pedal until the old brake fluid flows out of the brake
system.
I815H1410021-01
8) Close the air bleeder valve (1) and disconnect the
clear hose.
Tightening torque
Air bleeder valve (Rear) (a): 7.5 N·m (0.75 kgf-m,
5.5 lb-ft)
I815H1410022-01
4A-7
I815H1410023-01
I815H1410024-01
1
(a)
I815H1410025-03