Hazard Switch Inspection; Turn Signal Switch Inspection - Suzuki GSX1300R Manual

9B-10 Lighting Systems:
2) Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse
order of removal.

Hazard Switch Inspection

Inspect the hazard switch in the following procedures:
1) Remove the left upper panel. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
2) Disconnect the left handlebar switch coupler (1).
1
3) Inspect the hazard switch for continuity with a tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one. Refer to
"Handlebar Removal and Installation in Section 6B
(Page 6B-3)".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
B
Position
OFF
ON
4) After finishing the hazard switch inspection, reinstall
the removed parts.
1
I815H1920036-01
B815H29206020
I815H1920037-01
Sb Lg
I815H1920038-01

Turn Signal Switch Inspection

Inspect the turn signal switch in the following
procedures:
1) Remove the left upper panel. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
2) Disconnect the left handlebar switch coupler (1).
1
3) Inspect the turn signal switch for continuity with a
tester. If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to "Handlebar Removal and Installation in
Section 6B (Page 6B-3)".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
Lg
Position
L
PUSH
R
4) After finishing the turn signal switch inspection,
reinstall the removed parts.
B815H29206021
I815H1920039-01
Sb B
I815H1920040-02