Example Ospf Configuration - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

IP Routing—Configuring RIP, OSPF, BGP, and PBR
Configuring OSPF
To configure a simple password for an interface, move to the interface
configuration mode context and enter the following command:
Syntax: ip ospf authentication-key <password>
For example, enter the following command to configure secret as the pass-
word:
ProCurve(config-fr 1.101)# ip ospf authentication-key secret
To configure a message digest key, enter:
Syntax: ip ospf message-digest <key ID> md5 <key>
The key ID can be 1 or 2.
For example, you might enter:
ProCurve(config-fr 1.101)# ip ospf message-digest 1 md5 secret
N o t e
You must set the same password or key for each interface on a network, but
you can set different passwords or keys for different networks. However, you
must use the same type of authentication (none, simple, or MD5) for every
network in an area.

Example OSPF Configuration

Figure 13-14 shows an OSPF network with two remote sites. The networks at
the headquarters make up area 0; those at remote site A make up stub area 4;
and those at remote site B compose total stub area 5. In addition to an ABR
that connects to both remote sites, the headquarters contains an internal
router and an ASBR that connects to a RIP network. The ASBR should shuttle
routes between the OSPF and RIP networks.
13-61