HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 918

Using the Web Browser Interface for Advanced Configuration Tasks
Routing
N o t e
14-118
Complete these steps to advertise and enable OSPF on a network:
1. Access to the OSPF screen.
2. Move to the second window, Add a Network to be Advertised by OSPF.
Specify a network:
a. If your LAN uses OSPF, enter the network address and subnet mask
for the network on which your router has its Ethernet interface. Enter
these values in the IP Network and Subnet Mask fields. (See Figure
14-90.)
b. Specify the network's area. If your WAN does not use areas, enter 0.
If other routers in your WAN specify this network as a stub area, then you must
enter the area <area ID> stub OSPF configuration mode command in the
CLI. (See Chapter 13: IP Routing—Configuring RIP, OSPF, BGP, and PBR.)
Figure 14-90. Advertising an OSPF Network
c. Click Add.
d. Repeat steps a through c to add any other LAN networks on which
your router has an interface.
e. If you want your router to run OSPF between remote sites, you must
also add the networks for the router's WAN interfaces. Repeat steps
a through c.