HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 295

Replace <protocol> with one of the following:
icmp
ip
tcp
udp
ahp
esp
gre
You can also specify a port number between 0 and 255.
To specify a source address or destination address, you use the following
syntax:
Syntax: [any | host <A.B.C.D> | hostname <hostname> | <A.B.C.D> <wildcard bits>]
Table 6-3 shows the options for specifying source and destination addresses.
Table 6-3. Options for Specifying Source and Destination Addresses
Option
any
host <A.B.C.D>
hostname <hostname>
<A.B.C.D> <wildcard bits>
For example, if you want to select all the traffic destined for IP address
10.1.1.10, enter:
ProCurve(config-ext-nacl)# permit ip any host 10.1.1.10
If you select UDP or TCP as the protocol, you can also specify a source or
destination port (although you do not have to). For example, if you want to
configure one-to-one NAT for multiple devices, you should include a destina-
tion port as part of the criteria used to select traffic.
Table 6-4 shows the options you have for defining ports when you select UDP
or TCP as the protocol.
Configuring Network Address Translation
Meaning
match all hosts
specify a single host or a single IP address
specify a single host by name rather than by IP address
specify a range of IP addresses
Configuring NAT
6-11