HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 915

Using the Web Browser Interface for Advanced Configuration Tasks
5. Specify the networks that should participate in RIP in the Add a Network
to be Advertised by RIP window. Enter the network address in the IP
Network fields and the subnet mask in the Subnet Mask fields. (Note that
you enter a subnet mask rather than wildcard bits.)
The router will advertise routes to the specified networks. Only interfaces
that have an IP address on these networks participate in RIP, so remember
to advertise the networks on WAN interfaces as well as LAN interfaces.
6. Click Add.
7. Advertised networks display at the bottom of the window (for example,
network 192.168.1.0 /24 in figure 14-89).
Figure 14-89.Advertising a Network with RIP
8. Your router may connect to a network or networks that do not run RIP,
but that should still be advertised. In this case, you must check the
Redistribute Connected box in the RIP Configuration window.
9. If you want the router to advertise a static route, such as a default route,
check the Redistribute Static box in the RIP Configuration window.
10. Passive interfaces listen for RIP routes but do not send them. For example,
you can make an interface passive when it connects to an external
network that you do not want to receive information about your network.
You can also configure interfaces such as loopback interfaces to be
passive to eliminate redundant routing updates.
In the Passive Interfaces window, select the interface from the Disable
RIP on Interface pull-down menu and click Apply.
Routing
14-115