Virtual Private Networks
Quick Start
Parameters
crypto mapname
crypto map index number
8-90
Options
alphanumeric string
0 to 65,535
Local Router
LAN1
192.168.1.0/24
192.168.2.0/24
Local network
addresses
Figure 8-18. Sample VPN Configuration
Configuring a Site-to-Site VPN
You can print Table 8-31 and fill it out with the settings for your VPN. You can
then use the worksheet to complete the quick start commands. If the local
router will connect to more than one site, print and fill out a worksheet for
each site.
Figure 8-18 displays a simplified sample network, which you can consult as
you configure your router.
Complete these steps to configure a site-to-site VPN using IPSec with IKE:
1.
Install the IPSec VPN module.
2.
Enable VPN functions:
ProCurve(config)# ip crypto
Obtain Setting From
same name for every entry
establishing a connection on
the same interface
different index number for
every entry establishing a
connection to a different site
Internet
LAN2
Peer ID
Your Setting
10.2.2.2
Peer Router
LAN1
LAN2
192.168.4.0/24
192.168.5.0/24
Remote network
addresses