HP ProCurve Quick Setup Manual

HP ProCurve Switch Quick Setup Guide
These images are examples only. Your switch may look a little different.
➊
Unpack and check included parts:
• Switch
• Switch Quick Setup Guide
• Read Me First
• Safety and Regulatory booklet
• Customer Support/Warranty booklet
• Console cable
• Accessory kit
• Power cord
➋
Prepare for installation.
To avoid personal injury or product damage, review
the installation guidelines on the next page.
➌
Verify selftest by connecting the power cord.
Test LED
Power and
Fault LEDs
➍
Install mounting brackets.
➎
Mount the switch and connect the power cord.
➏
➐
Port LEDs
By default, the switch is configured to acquire an IP address config-
uration from a DHCP or Bootp server.
For more information on configuration and remote management, see
the Management and Configuration Guide for your switch, which is
on the ProCurve Web site at
➑
For more installation information refer to the Installation
and Getting Started Guide for your product, located on
the HP ProCurve Web site at:
www.procurve.com/manuals.
Note: Before installing the switch in a rack, check the
Installation and Getting Started Guide for specific rack
installation instructions.
(Optional) Connect console cable.
Configure (minimal configuration).
www.procurve.com/manuals.
Connect network cables.
RJ-45
connector
Console
cable
To PC
Fiber cable
connector