Enter times in twenty-four hour clock format. For example:
ProCurve(config-fr 1.102)# no backup schedule saturday
ProCurve(config-fr 1.102)# backup schedule disable-time 18:00:00
ProCurve(config-fr 1.102)# backup schedule enable-time 8:00:00
14. If you are using static routing, add a floating static route to the remote
site. From the global configuration mode context, enter:
Syntax: ip route <remote network A.B.C.D> [<subnet mask> | /<prefix length>]
[<remote backup A.B.C.D> | ppp <backup interface number>] [<administrative
distance>]
Set the administrative distance higher than the route through the primary
connection so that the router will only add the backup route to its table
if the primary connection fails. For example, enter:
ProCurve(config)# ip route 192.168.3.0 /24 ppp 2 2
Backing up a Connection with an ISDN BRI S/T Backup
Module
1.
Install the backup module. Refer to the "Installation Instructions" in the
ProCurve Secure Router dl ISDN BRI S/T Backup Module Quick Start
Guide.
2.
Power up the router and move to the global configuration mode context.
Enter the BRI interface configuration mode context.
Syntax: interface bri <slot>/<port>
3.
Enter the ISDN signaling type.
Syntax: isdn switch-type [basic-ni | basic-net3 | basic-dms | basic-5ess]
For example:
ProCurve(config-bri 1/3)# isdn switch-type basic-net3
4.
Enter the LDN.
Syntax: isdn ldn1 <local site's LDN>
5.
If necessary, enter a second LDN.
Syntax: isdn ldn2 <local site's LDN 2>
6.
Activate the interface.
ProCurve(config-bri 1/3)# no shutdown
Configuring Backup WAN Connections
Quick Start
3-105