Specifying Ospf Networks - HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
You may not need to divide a simple network into areas. In this case, you
should place all subnets in area 0. See Chapter 13: IP Routing—Configuring
RIP, OSPF, BGP, and PBR for more information on designing areas.
Your main task when using the Web interface to configure OSPF is to specify
OSPF networks.
Optionally, you can:
redistribute non-OSPF routes into the protocol
enable the router to generate and advertise a default route for external
traffic
advertise summary routes
configure global OSPF parameters:
• the metric for redistributed routes
• global OSPF timers
• the reference bandwidth for computing connections' cost
configure parameters for individual OSPF interfaces:
• link cost
• OSPF timers
You must configure other OSPF options from the CLI.
In order to complete any OSPF configuration task, you will need to access the
OSPF windows. You can do so by completing these steps:
1. Select Routing under Router/Bridge in the lefthand navigation bar.
2. The Dynamic Routing Protocols window displays the routing protocols
supported by the ProCurve Secure Router. Click the Configure button for
OSPF.
When you are configuring advanced OSPF options, you can return to the main
OSPF windows, by selecting OSPF from the top navigation bar.

Specifying OSPF Networks

When you enable OSPF on a network, you enable:
router interfaces on that network to run OSPF (send hellos and LSAs)
all OSPF interfaces on the router to send LSAs for that network
When specifying a network, you must also place the network in an area.
Routing
14-117