HP ProCurve Secure Router 7203 dl Advanced Management And Configuration Manual page 182

Configuring Backup WAN Connections
Quick Start
Required Configuration
Access the configuration mode
context for the backup interface.
For an analog interface, specify the
country in which the router is located.
For ISDN connections, specify the
ISDN signaling that the service
provider implements on the line.
For ISDN connections in North
America, specify the service profile ID
(SPID).
For ISDN connections, specify the LDN,
the local telephone number for the
ISDN line.
Create a backup PPP interface.
Specify an IP address for a backup PPP
interface.
Specify the number to call to reach far-
end network.
Determine whether the router can
place or answer backup calls, or both.
3-102
Table 3-22. Backup Settings
Options
<backup interface> = bri or modem
<slot> = 1 or 2
<port> = 2 or 3
Enter modem country code ? for a
complete list of codes. (Enter this
command from the global
configuration mode context.)
• • National ISDN-1= basic-ni
• Euro ISDN = basic-net3
• Northern Telecom DMS-100 =
basic-dms
• Lucent/ATT 5ESS = basic-5ess
Obtained from service provider
Obtained from service provider
Specify a number between 1 and 1024:
interface ppp <number>
Different network address than the
address assigned to the primary
connection
Obtained from remote site
• • originate
• answer
• answer-always (answer backup
calls even when the local
connection is good)
• originate-answer (default)
• originate-answer-always
Your Setting