Formed Tube Grommet Diagram; Horizontal Drain Trap Grommet Diagram; Modify Drain Tube Diagram; Drain Trap Connection And Routing - Carrier 59TN6A Installation, Start-Up, Operating And Service And Maintenance Instructions

INSTALL CLAMPS ON DRAIN TUBE
ATTACH DRAIN TUBE TO CONDENSATE?
DRAIN TRAP
PULL DRAIN STUB /
/
THROUGH CASING / /
/' / "_\
' : / \
/ \
/
/ _,
J
/
NOTE: Trap grommet is required only for direct-vent
applications.
OPEN SPRING CLAMP
INSERT FACTORY-SUPPLIED 1/2-1N. CPVC
TO 3/4-1N. PVC ADAPTER OR 1/2-iN CPVC PtPE
*CLAMP MAY BE LOCATED ON OUTSIDE OF DRAIN
TUBE
RIGHT SiDE DRAIN iNSTALLATiON
Fig. 14 - Formed Tube Grommet
Al1342A
Remove knockout,
Install grommet before
relocating condensate
trap.
Fig. 16 - Horizontal Drain Trap Grommet
Al1582
Attach tube to condensate
Cut line for left side condensate drain.
Do not disc
T
l !
1-3/8 in
(35 ram)
Cut formed end off
condensate drain tube
Formed end of
grommet
Connect short end
of "Z" pipe to modified
ube
Factory supplied 1/2-in. CPVC to
3/4-in. PVC adapter
TRAP, DRAIN ELBOW WITH DISCHARGE PIPE
Formed end of grommet
Open spring clamp. Insert
1/2-in. to 3/4-in. CPVC to
PVC adapter or 1/2-in.
CPVC pipe
Modified drain tube connect to
condensate trap and "Z" pipe
Fig. 15 - Modify Drain 1hbe
Al1581
LEFT SIDE DRAIN ROUTED BEHIND INDUCER
Fig. 17 - Drain Trap Connection and Routing
(Appearance May Vary)
Al1583
18