Room Eq - Sherwood R-977 Operating Instructions Manual

OSD Menu Settings
4
Press the CURSOR UP()/DOWN() buttons
to select the Auto Setup, and then press the
CURSOR RIGHT() button.
TEST SETUP
DISC MENU HOME MENU
ENTER
DISPLAY RETURN
DISPLAY DIMMER
PURE MONITOR
AUDIO SELECT AUDIO SUBTITLE
SURROUND STEREO
5
Press the CURSOR RIGHT() button to start the
auto setup procedure.
• Loud test tones are output successively and
then if a series of auto setup procedure has
been completed, "COMPLETED" will be
displayed.
•
To stop the auto setup procedure while
performing it, press the CURSOR LEFT()
button.
• If there may be a problem with speaker or
microphone connection, error message will
be displayed. In this case, turn off the power,
check the connection and then retry the auto
setup procedure.
TEST
DISC MENU
DISPLAY
DISPLAY
PURE MONITOR
AUDIO SELECT
SURROUND
58
TEST SETUP
DISC MENU HOME MENU
ENTER
DISPLAY RETURN
DISPLAY DIMMER
PURE MONITOR
AUDIO SELECT AUDIO SUBTITLE
SURROUND STEREO
SETUP
HOME MENU
ENTER
RETURN
DIMMER
AUDIO SUBTITLE
STEREO
6
Memorize the results by pressing the CURSOR
RIGHT() button.
• The results are memorized and the Speaker/
Room EQ Setup menu is displayed.
• When the CURSOR LEFT() button is pressed
to select "CANCEL", the results are not
memorized.
• Check the results on each setup menu
("Speaker Config", "Speaker Crossover",
"Speaker Distance" and "Channel Level" menu
for "Calibrate" mode on page 59).
TEST
D SC MENU
D SPLAY
DISPLAY
PURE MONITOR
AUDIO SELECT
SURROUND
7
Disconnect the microphone after you have
completed the auto setup procedure.
Caution
• Because the test tones are loud, ensure there no
infants or young children in the room.
Note
• For best results, ensure the room is as quiet as
possible during the auto setup procedure. If there
is too much ambient noise, the results may not be
satisfactory.
• If the results are not satisfactory, you can retry the
auto setup procedure or personalize your speaker
setup and channel level setup by making the settings
manually. For details, see "Speaker Config", "Speaker
Crossover", "Speaker Distance" and "Channel Level"
procedure on page 59.
• After the auto setup has been completed, set the
Room EQ as desired. For details, see "Room EQ" on
page 58.

Room EQ

You can adjust the Room EQ as desired after
performing the Auto Setup procedure.
Menu item
On Turn the Room EQ function on
Off Turn the Room EQ function off
SETUP
HOME MENU
ENTER
RETURN
DIMMER
AUDIO SUBTITLE
STEREO
Description