Av Sync; Dc Trigger1 & Dc Trigger2; Setting The Hdmi Setup; Setting The Hdmi Setup - Sherwood R-977 Operating Instructions Manual

AV Sync

There may be a slight time delay between the

video and audio signals in case that some video
playback equipment may process the video
signals later than the audio signals due to signal
processing procedure, etc.. Should this happen,
you can adjust the time delay of audio signals to
synchronize the sound with the picture.
The time delay can be adjusted within the range of

0 ms ~ 200 ms.
Note
• The "AV Sync" cannot be selected on "TUNER",
"PHONO", and "F.AUX" configuration menus.
DC Trigger1 & DC Trigger2
To turn on the component connected to the DC
TRIGGER OUT jack when the input source is
selected, you should set the DC Trigger to ON for this
input source. For details, see "Connecting DC Trigger
OUT" on page 26.
Menu item
On Turn the DC Trigger function on
Turn the DC Trigger function off
Off
Description

Setting the HDMI Setup

Main Menu  HDMI Setup

HDMI Audio Output

BACK

CEC Control

TV Power Sync.

Auto AV Sync
Monitor Output
HDMI Audio Output: Output the digital audio

signals from the HDMI MONITOR OUT connector
CEC Control: Link operations with components

connected to HDMI connectors and compatible
with HDMI control
 TV Power Sync.: Link the power ON/OFF status of
this receiver to TV
 Auto AV Sync: Adjust the time delay automatically
between the video and audio signals
 Monitor Output: Output the digital video signals
from the HDMI MONITOR OUT connector

HDMI Audio Output

The HDMI connection can carry uncompressed digital
video signals and digital audio signals. Depending on
whether the digital audio signals input into the HDMI
IN are output from the HDMI MONITOR OUT of
this receiver or not, you should set the HDMI Audio
Output correctly.
Menu item
Disable HDMI digital audio
signals output from the HDMI
MONITOR OUT of this receiver,
Speaker
meaning these signals are heard
from the speakers connected to
this receiver
Enable HDMI digital audio signals
output from the HDMI MONITOR
Passthrough OUT of this receiver, meaning
these signals are heard from the
speakers of your TV
Note
• If the HDMI Audio Output is set to "Passthrough", no
sound will be heard from the speakers connected to
this receiver (except ROOM 2 speakers) even though
any input source is selected.
OSD Menu Settings
NEXT
Description
63