Audio Mode; Video Scaling - Sherwood R-977 Operating Instructions Manual

OSD Menu Settings

Audio Mode

You can select the desired audio input signal to be
played.
Menu item
When there are multiple audio
input signals, the audio input
signals are detected and the
audio input signal to be played
Auto
is selected automatically in the
priority order of them: HDMI
audio > Digital audio > Analog
audio
The signal that is input into the
HDMI
HDMI IN is always played.
The signal that is input into
Digital the OPTICAL or the COAXIAL
DIGITAL IN is always played.
The signal that is input into the
Analog analog AUDIO INs is always
played.
Note
• Be sure to set the Audio Mode to the audio input
which is connected and assigned to the selected input
source.
• When the HDMI Audio Output is set to "HDMI
Passthrough", no sound will be heard from the
speakers connected to this receiver (except ROOM 2
speakers).
• When the Audio Mode is set to HDMI, you should
connect the HDMI INs and set the HDMI Assign
correctly. If not, the "HDMI" indicator flickers on the
fluorescent display and no sound will be heard.
• When the Audio Mode is set to Digital, you should
connect the DIGITAL INs and set the Audio Assign
correctly. If not, the "DIGITAL" indicator flickers on the
fluorescent display and no sound will be heard.
62
Description

Video Scaling

You should set the resolution of video signals

to be output from the HDMI MONITOR OUT to
match that of your TV. For details on the resolution
compatible with your TV, refer to the operating
instructions of your TV.
When the HDMI MONITOR OUT is connected

to an HDMI-compatible TV, the TV reports to this
receiver what resolutions it supports. Therefore,
if you set the Video Scaling to "AUTO", this
receiver outputs the video signals of the optimum
resolution acceptable for your TV.
Menu item
Convert the video signals being
input to the video signals of the
Auto highest resolution acceptable for
TV and to output them from the
HDMI MONITOR OUT.
Output the video signals at the
HDMI Bypass same resolution that they are
input, with no conversion.
Convert the video signals to
480p/576p 480p(NTSC) (or 576p(PAL)) video
signals and output them.
Convert the video signals to 720p
720p
video signals and to output them.
Convert the video signals to
1080i 1080i video signals and output
them.
Convert the video signals to
1080p 1080p video signals and to
output them.
Note
• If the resolutions of the video signals which are output
from the HDMI MONITOR OUT and your TV are not
matched, the picture is not clear, natural or displayed.
• When 1080/24p video signals or 3D video signals,
PC base video signals are input into the HDMI IN, the
Video Scaling is automatically set to "HDMI Bypass".
• When the Video Mode is set to "Composite" and the
Video Scaling is set to "HDMI Bypass", the 480p/576p
video signals will be output from the HDMI MONITOR
OUT.
• When the Video Scaling is set to "HDMI Bypass"
and the video signals are input into the HDMI IN,
the momentary OSD cannot be displayed via HDMI
MONITOR OUT.
Description