Related Manuals for Sherwood RX-4503
Summary of Contents for Sherwood RX-4503
- Page 1 2008.8.12 3:44 PM 페이지 2 OPERATING INSTRUCTIONS RX-4503 AM/FM STEREO RECEIVER...
-
Page 2: Important Safety Instructions
RX-4503(A) 2008.8.12 3:43 PM 페이지 3 IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. -
Page 3: Introduction
RX-4503(A) 2008.8.12 3:43 PM 페이지 4 Introduction READ THIS BEFORE OPERATING YOUR UNIT TO REDUCE THE RISK OF ELECTRIC SHOCK, CAUTION : DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. -
Page 4: Table Of Contents
RX-4503(A) 2008.8.12 3:43 PM 페이지 5 CONTENTS • IMPORTANT SAFETY INSTRUCTIONS ... 3 Introduction • READ THIS BEFORE OPERATING YOUR UNIT ... 4 System Connections ... 6 Front Panel Controls ... 9 Remote Controls ... 11 • REMOTE CONTROL OPERATION RANGE ... 12 •... -
Page 5: System Connections
RX-4503(A) 2008.8.12 3:43 PM 페이지 6 System Connections • Do not plug the AC input cord into the wall AC outlet until all connections are completed. • Be sure to observe the color coding when connecting audio, video and speaker cords. - Page 6 RX-4503(A) 2008.8.12 3:43 PM 페이지 7 CONNECTING AUDIO COMPONENTS • The TAPE IN/OUT jacks can be connected to audio recording equipment such as a tape deck, an MD recorder, etc. • The AUX IN jacks can be connected to an additional components such as CD player, a tape deck, etc.
-
Page 7: Connecting Speakers
RX-4503(A) 2008.8.12 3:43 PM 페이지 8 CONNECTING SUBWOOFER PRE OUT • To emphasize the deep bass sounds, connect a powered subwoofer. CONNECTING SPEAKERS • Usally SPEAKER A terminals are used for only a pair of speakers. When you have another pair of speakers, SPEAKER B terminals can be used. -
Page 8: Front Panel Controls
RX-4503(A) 2008.8.12 3:43 PM 페이지 9 Front Panel Controls 1. POWER switch 2. POWER ON/STANDBY button 3. STANDBY indicator 4. FLUORESCENT DISPLAY For details, see below. 5. INPUT SELECTOR knob 6. SOUND button 7. BAND button 8. TUNING UP/DOWN (▲/▼) buttons 9. - Page 9 • When not using the FRONT AUX IN jack and the Bluetooth IN connector, cover these with the supplied cap. Bluetooth IN CONNECTOR • If the Bluetooth IN connector is connected to Sherwood Audio Receiver BT-R7(sold separately) with Bluetooth wireless technology, you can enjoy music wirelessly with a music player featuring Bluetooth wireless technology such as MP3 player, mobile phone, etc..
-
Page 10: Remote Controls
RX-4503(A) 2008.8.12 3:43 PM 페이지 11 Remote Controls... -
Page 11: Remote Control Operation Range
RX-4503(A) 2008.8.12 3:43 PM 페이지 12 REMOTE CONTROL OPERATION RANGE LOADING BATTERIES Remove the cover. • Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor. -
Page 12: Operations
RX-4503(A) 2008.8.12 3:43 PM 페이지 13 Operations LISTENING TO A PROGRAM SOURCE Before operation • Push the POWER switch. In the standby mode, turn the power on. POWER Switch the desired speakers on. Select the desired input source. • Each time the INPUT SELECTOR knob is rotated, the input source changes as follows : →... - Page 13 RX-4503(A) 2008.8.12 3:43 PM 페이지 14 Operate the selected component for playback. Adjust the (overall) volume. To mute the sound. To listen with the headphones. • Then the MUTE indicator will flicker. • To resume the previous sound level, press it again.
- Page 14 RX-4503(A) 2008.8.12 3:43 PM 페이지 15 Selecting a surround sound mode Surround sound modes • Dolby Virtual Speaker This mode creates a virtual surround sound field using as few as two front speakers and subwoofer, allowing you to experience listening from 5.1 channel speakers.
- Page 15 RX-4503(A) 2008.8.12 3:43 PM 페이지 16 Adjusting the tone (bass and treble) Select the desired tone mode. When the TONE is set to ON to adjust the tone (bass and treble). Adjust the tone (treble and bass) as desired. • Each time this button is pressed, the tone mode is selected as follows : OFF : To listen to a program source without the tone effect.
-
Page 16: Listening To Radio Broadcasts
RX-4503(A) 2008.8.12 3:43 PM 페이지 17 LISTENING TO RADIO BROADCASTS Auto tuning Select the desired band. Press the TUNING UP/DOWN buttons for more than 0.5 second. Manual tuning • Manual tuning is useful when you already know the frequency of the desired station. - Page 17 RX-4503(A) 2008.8.12 3:43 PM 페이지 18 Manual presetting • You can store up to 30 preferred stations in the memory. Tune in the desired station with auto or manual tuning. Press the MEMORY button. Select the desired preset number (1~30) and press the MEMORY button.
-
Page 18: Recording
RX-4503(A) 2008.8.12 3:43 PM 페이지 19 RECORDING • The analog signals from the EXTERNAL INs can be heard but cannot be recorded. • The volume and tone (bass, treble) settings have no effect on the recording signals. Recording with TAPE Select the desired input as a recording source except for TAPE. -
Page 19: Troubleshooting Guide
RX-4503(A) 2008.8.12 3:43 PM 페이지 20 Troubleshooting Guide If a fault occurs, run through the table below before taking your receiver for repair. If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation, consult with your dealer. -
Page 20: Specifications
RX-4503(A) 2008.8.12 3:43 PM 페이지 21 Specifications AMPLIFIER SECTION •Power output, stereo mode, 8 Ω, THD 0.08 %, 40 Hz~20 kHz ... 2X100 W •Total harmonic distortion, 8 Ω, 100 W, 40 Hz~20 kHz ... 0.02 % •Intermodulation distortion 60 Hz : 7 kHz= 4 : 1 SMPTE, 8 Ω, 100 W ... 0.02 % •Input sensitivity, 47 kΩ... - Page 21 2008.8.12 3:44 PM 페이지 1 RX-4503 AM/FM STEREO RECEIVER 5707-00000-120-0S...