Setting The System Setup; Setting The System Setup; Amp Assign; Rs232 Control - Sherwood R-977 Operating Instructions Manual

OSD Menu Settings

Setting the System Setup

Main Menu  System Setup

AMP Assign

BACK

RS232 Control

Momentary OSD

Save/Recall

 AMP Assign: To assign the power amplifier
correctly depending on the purpose of the
speaker.
 RS232 Control: To turn on or off the RS232 control
function
 Momentary OSD: To turn on or off the OSD that
shows the status corresponding to each operation
momentarily
Save/Recall: To memorize all the OSD menu

setting values into memory or to recall the
memorized setting values
AMP Assign
The surround back channels' power amplifier can
drive the surround back speakers, the ROOM 2
speakers. Depending on the purpose of the speakers,
you should assign the power amplifier correctly. For
details, see "Connecting Speakers" on page 21 and
"Connecting Room 2 and Room 3 Outs" on page 24.
Menu item
When connecting this receiver to
the surround back speakers, front
height speakers, and the ROOM
2 speakers simultaneously, the
Auto(SB/FH/ power amplifier automatically
R2) drives the surround back
speakers, front height speakers
or ROOM 2 speakers depending
on whether the ROOM 2
function is turned off or on
To drive the surround back
speakers when connecting the
Surround Back
SURROUND BACK channels to
them
To drive the front height
Front Height speakers for Dolby Pro Logic IIz
playback
To drive the ROOM 2 speakers
Room2
for ROOM 2 playback
56
NEXT
Description
RS232 Control
RS232 control is required for connecting to Home
network or updating the firmware of this receiver.
Menu item
To use the RS232 Control
On(Power On) function only when the receiver
is turned on
Always use the RS232 Control
On(Always)
function
Not to use the RS232 Control
Off
function

Momentary OSD

Menu item
To turn the OSD function that
shows the status corresponding
On
to each operation on this receiver
momentarily
Off To turn it off
Note
• The OSD menu and the momentary OSD can be
displayed via the HDMI MONITOR OUT only. However,
when the Video Scaling is set to "HDMI Bypass", they
cannot be displayed via the HDMI MONITOR OUT.
For details, see "Video Scaling" of "Setting the Input
Setup" on page 62.
Save/Recall
You can memorize all the OSD menu setting values
into memory 1 ("Save 1") or memory 2 ("Save 2")
and recall the memorized setting values whenever
you want.
Menu item
To memorize all the OSD menu
Save 1
setting values into memory 1
To memorize them into memory
Save 2
2
To recall the setting values
Recall 1
memorized into memory 1
To recall the setting values
Recall 2
memorized into memory 2
Description
Description
Description