Group Auth. (Group Authorization Settings) - Kyocera ECOSYS M3040dn Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

Group Auth. (Group Authorization Settings)

Set restrictions of the machine usage by each individual group registered in the authentication server.
NOTE
• To use the group authorization settings, [Netwk Authentic.] must be selected for the authentication method in
Enabling User Login Administration on page
• Setting to use group authorization is performed from the operation panel. The groups should be registered with
Command Center RX. For details, refer to the Command Center RX User Guide.
1
2
9-3. Select "On" for "LDAP" in
Display the screen.
1
Press the [System Menu/Counter] key.
2
Press the [▲] or [▼] key to select [User/Job Account], and press the [OK] key.
Sys. Menu/Count.:
Counter
02
System/Network
03
04 User/Job Account
Exit
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and press [Login].
The factory default login user name and login password are set as shown below.
Login User Name
4000
3
Press the [▲] or [▼] key to select [User Login Set.], and press the [OK] key.
Configure the setting.
1
Press the [▲] or [▼] key to select [Group Auth.], and press the [OK] key.
2
Press the [▲] or [▼] key to select [Off] or [On], and press the [OK] key.
Protocol Detail on page
4000
9-18
8-9.
Login Password