Using A Custom Box; Creating A New Custom Box - Kyocera ECOSYS M3040dn Operation Manual

Operation on the Machine > Using a Custom Box

Using a Custom Box

Custom Box is a component box which you can create within the Document Box and store data for later retrieval. You
can create or delete a Custom Box, and manipulate data in various ways as described below:
Creating a New Custom Box (page 5-34)
Storing Documents (page 5-38)
Printing Documents (page 5-38)
Editing Documents (page 5-40)
Deleting Documents (page 5-41)
NOTE
The operation on Custom Box you perform from operation panel can also be made using Command Center RX. For
details on Command Center RX, refer to Command Center RX User Guide.

Creating a New Custom Box

NOTE
• To use Custom Box, an optional SSD must be installed in the machine.
• If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
The factory default login user name and login password are set as shown below.
4000
• If user login administration is enabled, log in with administrator privileges to perform the following operations. They
cannot be performed with user privileges.
- Creating a box
- Deleting a box of which owner is another user.
1
Login User Name
Display the screen.
1
Press the [System Menu/Counter] key.
2
Press the [▲] or [▼] key to select [Document Box], and press the [OK] key.
Sys. Menu/Count.:
09 Send
10 FAX
Document Box
11
Exit
3
Press the [▲] or [▼] key to select [Custom Box], and press the [OK] key.
Document Box:
Custom Box
01
02 Sub Address Box
03 Job Box
Exit
Login Password
4000
1
1
5-34
2
2