Kyocera ECOSYS M3040dn Operation Manual page 57

Installing and Setting up the Machine > Default Settings of the Machine
7
Use the numeric keys or press the [▲] or [▼] key to set the subnet mask.
Subnet Mask:
0. 0. 0.
You can set any value between 000 and 255. The entry method is the same method as the IP
address.
8
Press the [OK] key.
9
Press the [▲] or [▼] key to select [Default Gateway], and press the [OK] key.
IPv4 Setting:
IP Address
03
Subnet Mask
04
05 Default Gateway
Exit
10
Use the numeric keys or press the [▲] or [▼] key to set the default gateway.
Default Gateway:
0. 0. 0.
You can set any value between 000 and 255. The entry method is the same method as the IP
address.
11
Press the [OK] key.
IMPORTANT
After changing the setting, restart the network from System Menu, or turn the
machine OFF and then ON.
Restart (page 8-17)
NOTE
The network can be configured from the computer by using Command Center RX. Refer to
the Command Center RX User Guide.
0
1
0
2-15
2