Table of Contents
Advertisement
Installing a PC Flash Card
Installing a PC Flash Card
The control module PC flash card contains a version of the system image software that is
installed at the factory. If you have a more recent system image and want to boot the XP
using the newer software, you must boot either from a PC card or from a TFTP server.
To install a PC card:
1.
Power off the XP. You cannot install or remove a PC card while the XP is running.
2.
Insert the PC card into either of the slots on the control module. You can choose either
slot.
Note:
3.
Lock the PC card into the slot by pushing the PC card all the way into the slot.
4.
Power on the XP. (See Powering On and Booting the Software
5.
To verify proper installation of the PC card, do one of the following:
–
Reboot the system and watch the boot messages for the messages shown in bold
type in the following example:
%SYS-I-FLASHCRD, Mounting 8MB Flash card
%SYS-I-FLASHMNTD, 8MB Flash card mounted
%SYS-I-INITSYS, initializing system (unknown)
%SYS-I-DSCVMOD, discovered 'control module' module in slot CM
%SYS-I-DSCVMOD, discovered '10/100-TX' module in slot CM/1
%SYS-I-DSCVMOD, discovered '10/100-TX' module in slot 3
%SYS-I-DSCVMOD, discovered '10/100-TX' module in slot 4
%SYS-I-DSCVMOD, discovered '10/100-TX' module in slot 7
%SYS-I-INITPORT, initialized slot CM/1, port 1
%SYS-I-INITPORT, initialized slot CM/1, port 2
%SYS-I-INITPORT, initialized slot CM/1, port 3
%SYS-I-INITPORT, initialized slot CM/1, port 4
%SYS-I-INITPORT, initialized slot CM/1, port 5
%SYS-I-INITPORT, initialized slot CM/1, port 6
%SYS-I-INITPORT, initialized slot CM/1, port 7
%SYS-I-INITPORT, initialized slot CM/1, port 8
%SYS-I-INITPORT, initialized slot 3, port 1
%SYS-I-INITPORT, initialized slot 3, port 2
%SYS-I-INITPORT, initialized slot 3, port 3
%SYS-I-INITPORT, initialized slot 3, port 4
%SYS-I-INITPORT, initialized slot 3, port 5
%SYS-I-INITPORT, initialized slot 3, port 6
%SYS-I-INITPORT, initialized slot 3, port 7
%SYS-I-INITPORT, initialized slot 3, port 8
78
Even though there are two slots on the control module, you cannot use two
PC flash cards at the same time.
on page
Enterasys Xpedition 8000/8600 Getting Started Guide
79.)
Advertisement
Table of Contents
