Table of Contents
Advertisement
THE FE-100F3 FAST ETHERNET INTERFACE MODULE, FPIM-05 AND FPIM-07
FDDI PORT INTERFACE MODULES, AND APIM-29 ATM PORT INTERFACE MODULE
USE CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING
SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES.
The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates
the need for maintenance checks or adjustments. The output is factory set, and does not allow any user adjustment. Class 1
Laser transceivers comply with the following safety standards:
• 21 CFR 1040.10 and 1040.11 U.S. Department of Health and Human Services (FDA).
• IEC Publication 825 (International Electrotechnical Commission).
• CENELEC EN 60825 (European Committee for Electrotechnical Standardization).
When operating within their performance limitations, laser transceiver output meets the Class 1 accessible emission limit of
all three standards. Class 1 levels of laser radiation are not considered hazardous.
When the connector is in place, all laser radiation remains within the fiber. The maximum amount of radiant power exiting the
fiber (under normal conditions) is -12.6 dBm or 55 x 10
Removing the optical connector from the transceiver allows laser radiation to emit directly from the optical port. The
maximum radiance from the optical port (under worst case conditions) is 0.8 W cm
Do not use optical instruments to view the laser output. The use of optical instruments to view laser output increases
eye hazard. When viewing the output optical port, power must be removed from the network adapter.
Enterasys Xpedition 8000/8600 Getting Started Guide
SAFETY INFORMATION
CLASS 1 LASER TRANSCEIVERS
SAFETY INFORMATION
CLASS 1 LASER TRANSCEIVERS
LASER RADIATION AND CONNECTORS
-6
watts.
Regulatory Compliance Information
-2
3
2
or 8 x 10
W m
sr-1.
vii
Advertisement
Table of Contents
