B.3.2
Installing the FLASH Module
CAUTION: Observe all antistatic precautions when handling sensitive electronic
equipment.
To install a FLASH module, refer to
1. With the FLASH module oriented as shown in
between the connector.
2. Pivot the FLASH module downward so the connector clips align with the two side notches of
the FLASH module and the connector clips lock the FLASH module into place.
Figure B-3 Installing the FLASH
Figure B-3
and proceed as follows:
Figure
Mode Switch Bank Settings and Options
B-3, insert the FLASH module down
FLASH Upgrade
B-5