Table of Contents
Advertisement
Installing the Hardware
Because of the XP-8600 DC supply current requirements, each pole of the 48 Volt DC
source should use 6 gauge wire. Each 6 gauge wire can be divided into two 12 gauge wires
by using a conductive splitter-block. This creates two 12 gauge wires carrying positive (+)
current and two 12 gauge wires carrying negative current. In turn, both 12 gauge positive
(+) wires and both 12 gauge negative (-) wires are connected to the XP-8600 DC power
supply wiring block. See
56
XP-8600 DC Power Supply
Internal Power Supply One
Internal Power Supply Two
Figure 28. Relationship of wiring lugs on XP-8600 DC power supply
Figure
29.
These lugs supply power
to Power Supply One
These lugs supply power
to Power Supply Two
Enterasys Xpedition 8000/8600 Getting Started Guide
Advertisement
Table of Contents
