Table of Contents
Advertisement
The XP-8600 DC power supply has a five-terminal wiring block on the front panel,
consisting of two positive (+) terminal, two negative (-) terminal and a safety ground. The
DC supply is designed to be powered by a 48-Volt DC source.
DC Power Supply Specifications
The following table lists the physical specifications for the XP's DC Power Supplies.
Dimensions
Weight
Power Output
Voltage Range
The following table lists the environmental specifications for the XP's DC Power Supplies
Operating Temperature
Non-operating
temperature
Operating Humidity
Switching Fabric Module (XP-8600 only)
On the XP-8600, the switching fabric is contained on a separate plug-in module. The XP-
8600 has slots for two of these modules. When two switching fabric modules are installed,
the module in the slot labelled "Fabric 1" serves as the primary switching fabric module,
and the module in the slot labelled "Fabric 2" serves as a redundant switching fabric
module.
Figure 8
shows the front panel of the XP-8600 Switching Fabric module.
G86-SWF
Offline
Hot
Online
Active
Swap
Enterasys Xpedition 8000/8600 Getting Started Guide
XP-8000
11.00" (L) x 7.70" (W) x 2.55" (H)
6.5 lbs. (2.95 kg)
300 W
36 to 72 V, 14 A @ 48 V nominal
+5 to +40 °C (41 to 104 °F)
-30 to +73 °C (-22 to 164 °F)
15 to 90% (non-condensing)
Figure 8. Front panel of XP-8600 Switching Fabric module
Hardware Overview
XP-8600
12.15" (L) x 7.70" (W) x 5.05" (H)
12.0 lbs. (5.45 kg)
600 W
36 to 72 V, 27 A @ 48 V nominal
Switching Fabric
17
Advertisement
Table of Contents
