Table of Contents
Advertisement
Software Installation and
This chapter provides the following Enterasys Xpedition (XP) software installation and
basic setup procedures:
•
Installing the PC flash card (if you are upgrading from the software version on the XP's
boot flash)
•
Powering on the XP and booting the software
•
Starting the Command Line Interface (CLI)
•
Using the CLI to add an IP interface, subnet mask, and default gateway for remote
management access
•
Setting up passwords
•
Setting up an SNMP community string and trap target
•
Setting the DNS server's IP address(es) and domain name
•
Setting the SYSLOG server and message level
•
Upgrading system image software
•
Upgrading the boot PROM software
•
Activating and saving configuration changes
Enterasys Xpedition 8000/8600 Getting Started Guide
Chapter 3
Setup
77
Advertisement
Table of Contents
