Table of Contents
Advertisement
Cabling and Connector Specifications
The following table lists the media specifications for the Quad Serial – C/CE line cards.
Port Type
Dual serial
1.
Connector cables for WAN line cards may be ordered from Enterasys Networks. For detailed
information, including part numbers, see Quad Serial – C and Quad Serial – CE Line Cards
LEDs
The Quad Serial – C/CE line cards use the following LEDs.
LED
Offline
Online
Per-port Link
Per-port Rx
Per-port Tx
Enterasys Xpedition 8000/8600 Getting Started Guide
Specification
•
V.35, X.21, EIA530, EIA530A, or RS449
•
LFH-60 high density connector; see Quad Serial – C and Quad
Serial – CE Line Cards
•
Recommended 3 meters (10 feet) segment length for standard
WAN line card-to-CSU/DSU data port.
Description
When lit, this amber LED on the left side of the line card indicates
that the line card is offline (powered off) but is ready for hot swap.
The Offline LED also is lit briefly during a reboot or reset of the XP
but goes out as soon as the control module discovers the line card.
When lit, this green LED indicates that the line card is online and is
ready to receive, process, and send packets if configured to do so.
Indicates that the line card detects a cable plugged into the port and
a good link is established.
Indicates when the port's transceiver receives data.
Indicates when the port's transceiver transmits data.
on page 72
for pin assignments
1
Hardware Overview
on page
72.
43
Advertisement
Table of Contents
