Table of Contents
Advertisement
3.
Lock down the left and right metal tabs to secure the switching fabric module to the
chassis.
4.
Use the #2 Phillips screwdriver to tighten the captive screws on each side of the
switching fabric to secure the switching fabric to the chassis.
Installing the Line Cards
You can install line cards in slots 1 to 7 (or 1 to 15 on the XP-8600). If you also plan to
install a redundant control module, you can install line cards in slots 2 to 7 (2 to 15 on the
XP-8600). You will need a #2 Phillips screwdriver to perform this procedure.
: The XP supports hot swapping. This means you can remove and insert line cards
Warning
while the XP is operating. However, you should not insert tools or body parts inside the
chassis while it is powered on. Doing so can cause electrical shock or equipment damage.
For more information on hot swapping, see Hot Swapping Line Cards and Control Modules
in the The TeraLink 2000 Series Library: User Reference.
Figure 34
figure describes how to do this.
Card Guides
Circuit Card
Metal Plate
To install a line card:
1.
If a cover plate is installed over the line card slot, use the #2 Phillips screwdriver to
remove it.
Enterasys Xpedition 8000/8600 Getting Started Guide
shows an example of how to install a line card. The procedure following the
G8M-HTXA2-08
1
SSR-8
Figure 34. Installing a line card
10/100BASE-TX
2
3
4
5
6
7
8
Installing the Hardware
63
Advertisement
Table of Contents
