Table of Contents
Advertisement
Line Card RJ-45 Connector
TXD (transmit data)
Unused
Unused
Figure 36
2.
Plug one end of the cable into the line card and the other end into the hardware at the
other end of the connection.
1000Base-T Line Card
To attach the segment cables to your 1000Base-T line cards:
1.
For all the 1000-Mbps ports, obtain copper cables that have the following pin
assignments. The RJ-45 connectors on the 1000Base-T line cards are configured as
Media Data Interface Crossed (MDIX). Use Cat-5 or higher wire.
2.
Plug one end of the cable into the line card and the other end into the hardware at the
other end of the connection.
You may use either crossover or straight cables. The ports uses internal logic to
Note:
accommodate either crossover wire or straight wire.
The 1000Base-T line card does not support 10/100 Mbps traffic.
Note:
Enterasys Xpedition 8000/8600 Getting Started Guide
shows the pin positions in the 10/100Base-TX connectors.
Figure 36. 10/100Base-TX RJ-45 connector
Pin Number
RJ-45 Connector at Other
6
RXD (receive data)
7
Unused
8
Unused
87654321
Installing the Hardware
End of Segment
69
Advertisement
Table of Contents
