Table of Contents
Advertisement
Use the following procedure to add the SNMP community string and specify the target
for traps.
1.
Ensure that you are in Enable mode by entering the enable command in the CLI.
2.
Ensure that you are in Configure mode by entering the configure command in the
CLI.
3.
Use the following commands to add an SNMP community string and set a target for
the traps.
snmp set community <community-name> privilege read
snmp set target <IP-addr> community <community-name>
Note:
4.
Use the show command to examine the command you have just entered into the
scratchpad.
5.
Use the save active command to activate the commands you entered in the previous
steps.
6.
To verify the changes, use the snmp show all command.
Here is an example of the commands and output for configuring SNMP and saving the
changes.
ssr# config
ssr(config)# snmp set community public privilege read-only
ssr(config)# snmp set target 16.50.11.12 community public
ssr(config)# save active
ssr(config)# exit
ssr# snmp show all
SNMP Agent status:
enabled mode
SNMP Last 2 Clients:
16.50.100.53 Mon Jun 18 10:31:27 2001
16.50.100.43 Mon Jun 18 10:31:22 2001
SNMP Chassis Identity:
not configured.
Trap Table:
Index Trap Target Addr Community String Status
----- none configured -----
Traps by Type:
Authentication trap: enabled
Link Up/Down trap: enabled
Enterasys Xpedition 8000/8600 Getting Started Guide
The target IP address must be locally attached to the XP. You cannot specify a
target that is connected to the XP by another router. If the IP address is more
than one hop away from the XP, configure the XP with a static route to the
target so that a cold start trap is sent.
Setting Up SNMP Community Strings
85
Advertisement
Table of Contents
